NiksNaks CanDoor2, door pocket can & bottle holder for 2006 or earlier vans

from £12.00

Please scroll down to read the full description & watch the video before ordering to ensure that it will fit your van. A holder to fit to the driver’s or passenger’s door pocket of your 2006 or earlier Fiat Ducato / Peugeot Boxer / Citroen Relay.

Fitment:

Candoor for driver's side, no Allen key Candoor for driver's side plus Allen key to fit it with Candoor for passenger side, no Allen key Candoor for passenger side plus Allen key to fit it with Candoors for both sides, no Allen key Candoors for both sides plus Allen key to fit them with

Quantity:

Add To Cart

The NiksNaks CanDoor2 gives a simple to install can & bottle holder at the rear edge of the door pocket on MOST (but not all !) Ducato / Boxer / Relay based motorhomes produced between 2002 and 2006 (X244 model) and some of the earlier 1994-2002 X230 model vans. Please see the pictures on this listing & watch the video below before you place your order, and compare them to the trim fitted to your van.

Your van MUST have the bottle holder at the end of the door pocket as shown in the pictures - if your van does not have this, sorry the CanDoor will not fit.
This listing assumes a right hand drive van, if yours is left hand drive then if you want the driver’s side order “passenger” and vice versa.

To fit the CanDoor you simply push the rubber fitting beneath the Candoor into the hole in your door pocket as shown, rotate it forward and back and press down gently on the allen bolt head to ensure it is seated properly, move it back against the outer edge of the door pocket - so there is a finger sized gap between the back of the CanDoor and the door of the van - and tighten the allen bolt. It quite literally takes seconds to fit, with no disassembling of your van. You can even buy the allen key to fit it as an option!