NiksNaks Fiamma Awning Leg Spanner

Another original idea from NiksNaks!  Do you find the adjustment knob on the leg of your Fiamma wind-out awning difficult to undo sometimes, or you can't always get it tight enough to stop the leg slipping down?  Then we have the solution for you.

This small precision laser-cut acrylic spanner slips over the head of the Aeroplane-shaped screw to make it much easier to tighten and loosen it, without damaging it.  It can be stored in the front rail of the awning, so it's always to hand - instructions below.

Small, neat spanner - only 4" / just over 10cm long - if you are using it to tighten the screw then be careful not to over-tighten it, it only needs to be done up gently, just enough to grip - if you can, just do it up without the spanner, if you do need to use it to tighten it, be gentle.  The main intention is you use this to undo the screw.We supply the spanner with a pair of self-adhesive magnets so you can store it inside the awning rail if you wish. 

Take the protective film off the spanner and stick 1 magnet to it.  It can be stored inside the awning rail, just to one side of the centre - wind your awning in and you'll see the awning arms fold inside the front rail, there is a small gap left between the end of them and the centre support, your spanner can go in this gap.  Clean the inside of the awning rail with the supplied alcohol wipe , let it dry for a minute then stick the other self-adhesive magnet in position.  The magnet will hold it firm but even if it did come off it it cannot fall out of the casing when the awning is folded away.